Diagram Dialog
This dialog allows you to specify diagram properties.
Note that default values for new diagrams can be specified using default diagram setting.
Diagram dialog includes several pages (Moves, Print area, details) that can be used to define diagram.
Diagram title
Diagrams can have title. Depending on diagram's settings this is shown as part of diagram.
Moves
Include move numbers
This is normally selected to print diagram with move numbers.
Remove captured
Normally all moves, including captured moves are show in diagram. However sometimes one wish to remove captured stones in diagram.
Include moves before diagram
This is special option to shows numbers for moves before diagram start. Normally only moves after diagram are numbered.
Change move numbering
Often move numbering is not consecutive, when creating alternative move sequences. In these cases diagram often start from move number 1.
Adjust number to 1...100
Move numbers larger that 100 are difficult to read. Thus usually first move in diagram is scaled to range 1..100.
Print Area
Often only part of board is included in diagram.
Print whole board
This include whole board into diagram.
Keep previous printing area
This uses print area from previous diagram. Thus if print area in previous diagram is changed, it changes also for this diagram automatically .
Print part of the board
This includes only part of the board into diagram. Diagram area can be changed in board below text, or in main editing window using command edit -> Set Print Area.
Details
Include Diagram Title
Includes diagram title in diagram.
Show range of move numbes
Shows range of move numbers in diagram along with title.
Print Board Coordinates
Includes board coordinated in diagram.
Print Exceptions
Includes exceptions in diagram.
Print Hoshi Points
Include hoshi points in diagram.
See also: